7-146459-5 - TE Connectivity AMP Connectors

Opinie klientów

Ocena: 10 Artykuły

• ECUb***h

  2026/09/22

  Used for repair of an older automotive ECU. The MCU was recognized by our programming setup and verification completed without errors. The repaired board now starts and communicates normally.

• RS48***ieldTech

  2026/09/16

  Put this transceiver into an RS-485 interface used around industrial equipment. Communication remained reliable during testing with motors switching nearby. Good result for the replacement board.

• Logi***b_Chris

  2026/09/8

  Purchased for a Cyclone III development project. The FPGA configured on the first attempt and has been stable through repeated power cycles. No problems with the I/O we are using.

• Circ***FixerTom

  2026/09/2

  Used this rectifier in a high-current power supply repair. Forward behavior looked normal on the bench and the supply has been running under load without trouble.

• Retr***UWorks

  2026/08/31

  Needed the exact ST10F269Z2Q6 for servicing an older control unit. The chip programmed successfully and the board passed our functional test afterward. Much easier than redesigning around a newer MCU.

• Andr***PCBLab

  2026/08/28

  I needed this ADC for an older data acquisition board. Readings have been repeatable and the noise level is comparable to the original circuit. Happy with the purchase.

• Leat***O'Keefe

  2026/08/20

  one of my hobbies is skydiving. and when i'm skydiving this works great.

• Ilen***

  2026/08/20

  This product works considerably well. It secretly improves my basketball by a lot.

• Indu***ialPower

  2026/08/17

  Installed this IGBT module in a power conversion cabinet. Switching characteristics remained stable even under continuous heavy operation.

• Nikh***ech

  2026/08/13

  Great low-power MCU for portable equipment. Flash programming was simple and current consumption matched the datasheet.

Napisz recenzję

Twój adres e -mail nie zostanie opublikowany.